General Information - CBE CB510 Instructions D'emploi

SWITCH-MODE BATTERY CHARGER

GENERAL INFORMATION

The 510/516 switch-mode battery charger has been
expressly designed for the caravanning and boating
sector and can automatically charge 12V
batteries, with different charging values according to
the position set using the selector positioned inside.
T he battery charger is protected against
4 phase automatic charging system
Phase 1: B attery charging with maximum current
until the end-charge voltage is reached:
Note: the end-
reached only if the battery is efficient.
Phase 2: End-charge
threshold is reached the charger
continues to operate for 90 minutes (lead
batteries) or 8 hours (gel batteries) with
constant voltage.
lead
-
of- charge voltage is
- when the end-charge
CHARGING LINE "IUoU"
V I
V
I Uo
V = Volt A = Ampere
overtemperature and the 12V
protected against short circuit and polarity inversion.
The high frequency switching technology allows
high performances with small dimensions and
limited weight.
Phase 3: Constant voltage holding 13.8V
batteries) or 13.5V
Phase 4: S tand-by
charger reaches the stand-by mode and
begins to operate again only when the
battery voltage is lower than 13V
C
I
t
Uo
U ST-BY
C = Carico - Load
outputs are
-
(lead batteries)
- After 10 hours, the battery
EN
(gel
.
7