Chopping - Beko HBA6702 Manuel D'utilisation

3 Operation
To prevent overflowing of the
C
mixture do not overfill the measuring
beaker (13) or bowl. Smaller amounts
are easier to process.
C
To prevent any accidents use the
beaker lid as anti-slip rubber pad by
putting the beaker base on the lid.
If you would like to use the blending
C
attachment directly in the pot, first
take the pot off the stove to prevent
the blending attachment from
overheating.

3.4 Chopping

Do not chop extremely hard items
such as coffee beans, ice cubes,
C
nutmeg, grains or bones. Remove
stalks from herbs, shells from nuts
and bones, tendons and gristle from
meat.
C
Cut the food in small pieces.
1. Put the chopping bowl (10) on an even surface.
2. Place the chopping blade (9) onto the fixed
shaft in the chopping bowl (10).
A
WARNING:
inserting the chopping blade (9) as
it is very sharp.
A
WARNING: Do not touch the
chopping blade with bare hands.
3. Place the ingredients in the chopping bowl (10).
4. Put the chopping lid (8) on the chopping bowl
(10). Make sure that the claws on the chopping
lid are firmly locked on the bowl.
10 / 78 EN
Be careful when
WARNING: Never operate the
A
appliance if the chopping lid is not
properly seated on the chopping
bowl, as this could damage the
chopping blade.
5. Put the motor unit (5) on the chopping lid (8).
Push the motor unit so that it is firmly locked
in place. Make sure the motor unit is securely
attached to the chopping lid.
C
During operation always hold the
chopping bowl with one hand to
prevent it from tipping over.
6. Insert the plug into the wall socket.
7. Press and hold down the On/Off button (3).
– The appliance starts operating.
8. Use the speed control (2) to select a speed or
press and hold the turbo button (4).
– The speed indicator LED (1) illuminates
according to the desired speed 1-6.
– While using the turbo button (4), all speed
indicator LEDs illuminate.
C
Do not
continuously for more than 10
seconds.
C
To achieve the best results press
the On/Off button or turbo button
intermittently.
9. Release the On/Off button (3) or turbo button
(4) when you finish the process and disconnect
the power plug from the wall socket. Remove
the motor unit (5) from the chopping lid (8) by
pushing the attachment release buttons (6) at
the sides of the appliance and pulling it off. Take
the chopping lid (8) off. Take the chopping blade
(9) out of the chopping bowl (10) carefully prior
to removing the chopped food.
Hand Blender Set / User Manual
use the appliance