Antec TRUEPOWER Manuel De L'utilisateur page 5

Figure 1.
AC-V
AC-ON
AC-OFF
HIGH
PS-ON
VB= 4.75V
+5V Wave Form
T2
T1
T3
TURN-ON ON-RING
POWER GOOD
4.1 REMOTE ON/OFF CONTROL
The power supply is turned on or off by TTL signal.
Active low Power supply turn on
Active high Power supply turn off
Remote On/Off Signal Characteristics
PS-ON MIN
Vil, input low voltage
Vil, input low current, Vin=0.4V
Vih, input High voltage, lin=-200uA 2.0V
Vih open circuit, lin=0
4.2 AUXILIARY +5VSB
This power supply is specifically equipped with an independent stand-by
+5V output current, 2.0A max. This output will always provide +5V
except when the AC line is cut-off.
4.3 AUTO RESTART
If the output of the power supply drops out of the regulation caused by AC line Voltage,
the power supply will automatically resumes normal operation only after the AC line
voltage returns to the specified operating range.
5.0 ENVIRONMENT:
Ambient operation temperature
Ambient operation relative humidity
Ambient storage temperature
Ambient storage relative humidity
LOW
P .G. WAVE FORM
T4
POWER FAIL
OFF-RING
HOLD-UP
T5
MAX
0.8V
-1.6mA
5.25
10°C to +50°C
20% to 85%
-40°C to +70°C
10% to 95%
6
6.0 CE REQUIREMENTS:
6.1 EMI
1. MEET FCC CLASS B
2. MEET EN55022 CLASS B
6.2 ESD
MEET IEC-801-2/8KV
6.3 EFT/BURST
MEET IEC-801-4/2KV
HIGH
6.4 SAFETY REQUIREMENTS
1. MEET UL 1950
2. MEET IEC 60950
7.0 MTBF
80,000 hours at 25°C (demonstrated)
8.0 DC CONNECTOR AND CASE REQUIREMENTS
ATX MAIN CONNECTOR (P1)
HOUSING: P/N P20-I42002 or equivalent.
TERMINAL: P/N I42002BS-2 or equivalent.
16AWG (Wire)
Orange (16AWG)
Orange (22AwG)
Blue (18AWG)
Black
Green (22AWG)
Black
Black
Black
White (18AWG)
Red
Red
Red (22AWG)
PERIPHERAL POWER CONNECTOR
(P2, P4, P6, P7, P8, P9, P10)
HOUSING: JMT JP1120-4
HOUSING: WST P4-A10202 OR EQU
TERMINAL: JMT J1120BS-2
TERMINAL: WST A10209BS-2
Pin
1 +12VDC
2 COM
3 COM
4 +5VDC
Signal Pin Pin
+3.3VDC 11
+3.3V
default sense
-12VDC 12
COM 13
PS-ON 14
COM 15
COM 6
COM 7
-5V 18
+5VDC 19
+5VDC 20 10
+5V
default sense
FLOPPY DRIVE POWER CONNECTOR
(P3, P5)
HOUSING: JMT JP11635-4
HOUSING: WST P4-I25001 OR EQU
TERMINAL: JMT J11635BS-2
TERMINAL: WST I25001BS-2 OR EQU
Pin
Signal 18AWG (Wire)
1
Yellow
2
Black
3
Black
4
Red
7
Signal 16AWG (Wire)
1 +3.3VDC Orange
2 +3.3VDC Orange
3 COM Black
4 +5VDC Red
5 COM Black
6 +5VDC Red
7 COM Black
8 POK Gray (18AWG)
9 +5VSB Purple (18AWG)
+12VDC Yellow
+12VDC Yellow (22AWG)
default sense
Signal 22AWG (Wire)
+5VDC Red
COM Black
COM Black
+12VDC Yellow