Publicité
Les langues disponibles
Les langues disponibles
Accidental restart preventive
function
If you install the battery cartridge while pulling the
switch trigger or locking the switch trigger, the tool does
not start. To start the tool, release the switch trigger, and
then pull the switch trigger.
Electronic function
The tool is equipped with the following electronic func-
tion for easy operation.
Soft start
The soft-start function minimizes start-up shock, and
makes the tool start smoothly.
Basic operations
CAUTION:
Do not mix flammable materials or
operate the tool around flammable materials such
as paint with thinner used as solvent. Failure to do
so may cause an injury.
CAUTION:
Do not mix high viscosity material
in the high speed mode. You may lose the control of
the tool and cause an injury.
CAUTION:
Do not rotate the mixing blade
outside the stirring vessel.
CAUTION:
If you hear an abnormal noise
during use, turn off the switch and stop using the
tool.
NOTICE:
When you mix the material while the
mixing blade floating out of the material, be care-
ful not to splash the material.
NOTICE:
Do not use the tool for any purpose
other than stirring mortar, concrete, etc.
1.
Select high speed mode or low speed mode
according to the material to be mixed.
2.
Hold the tool firmly with both hands. Place the mix-
ing blade under material fully. Check that the material is
not solidified and the safety of the work site, then turn
on the tool.
3.
Move the mixing blade up and down during the
mixing operation so that whole part of material can be
mixed.
4.
When finishing mixing, turn off the tool. Make sure
that the mixing blade has come to a complete stop, and
then pull it out of the mixing container.
Handling after use
Use a wet cloth or the like to carefully wipe off the mate-
rial left on the tool after use. Extra care should be given
to thorough cleaning of the vents, switch area, cover
openings, etc.
NOTICE:
Avoid cleaning the tool in water. Water
will get into the motor housing and cause motor
failure.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Troubleshooting
Before asking for repairs, check the following points.
1.
Turn the tool off, and then turn it on again to
restart.
2.
Charge the battery(ies) or replace it/them with
recharged battery(ies).
3.
Let the tool and battery(ies) cool down.
If no improvement can be found by restoring protection
system, then contact your local Makita Service Center.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
•
Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
MAKITA LIMITED WARRANTY
Please refer to the annexed warranty sheet for the
most current warranty terms applicable to this product.
If annexed warranty sheet is not available, refer to the
warranty details set forth at below website for your
respective country.
United States of America: www.makitatools.com
Canada: www.makita.ca
Other countries: www.makita.com
9 ENGLISH
Publicité
