Store The Machine; Troubleshooting; Technical Data - GreenWorks DT40L00 Manuel D'utilisation

WARNING
Use only approved replacement tines.
WARNING
Wear adequate clothing, gloves and goggles before carrying
out any maintenance.
WARNING
All the screws to mount the halves of the tine holder (21)
must be installed with washers (17) and lock nuts(18) to
avoid loosening during use.
1. Stop the machine.
2. Make sure that the cylinder fully stops.
3. Remove the battery pack.
4. Turn the machine to its side to expose the cylinder (6).
5. Identify the worn or broken tine (20).
6. Untighten the screws (16), washers (17) and lock nuts
(18) to remove the tine holder (21) bearing the worn or
broken tine.
7. Take out the pin (19) and the worn or broken tine.
8. Replace with a new tine (20). Insert the pin (19) through
the new tine into the holder.
9. Re-install the tine holder back to the cylinder.
10. Tighten the screws, washers and nuts in original order.
10.3

STORE THE MACHINE

• Clean the machine before storage.
• Make sure the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person at an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
English
11

TROUBLESHOOTING

Abnormal noise.
Clattering in the
unit. Whistling
sound.
Whistling sound.
Motor will not
start.
The dethatcher is
hard to push.
Dethatching re-
sults are not satis-
factory.
* If you cannot find the solution to these problems, go to the
service center.
12

TECHNICAL DATA

Voltage
9
Foreign objects on Switch off the de-
the dethatcher cyl- thatcher, wait until
inder are hitting the cylinder has
the dethatcher. stopped rotating.
Foreign objects Remove foreign
blocking the de- objects.
thatching cylinder.
Check the de-
thatcher immedi-
ately.
Belt slipping. Contact an author-
ized service cen-
tre.
Battery is not se- Ensure that the
cure. battery is fully se-
cured in the ma-
chine. Refer to In-
stall the Battery
section in this
manual.
Battery is not Charge the battery
charged. pack according to
the instructions in-
cluded with your
model.
Blocked by for- Switch off the mo-
eign objects. tor, wait until the
tine cylinder
comes to a com-
plete stop. Re-
move the foreign
objects. After ap-
proximately one
minute, switch on
the dethatcher.
The grass is too Mow the lawn be-
tall. fore dethatching.
Spring tine wear. Adjust the de-
thatcher cylinder.
Belt fault. Contact an author-
ized service cen-
tre.
Lawn has grown Mow the lawn be-
too tall. fore using thede-
thatcher.
40 V
EN