Durant E4148794 Mode D'emploi page 6

Programming
• Press and hold PGM for 3 seconds to enter Programming mode.
• Press Digit 1 to cycle through the
menus, or PGM to exit
Programming mode.
• Press SEL to select a menu, then
Digit 1 to cycle through the
options.
• Press SEL to select an option, or
PGM to exit the menu without
change.
• Press the Digit buttons to adjust a
numerical setting, eg. pulse time.
• Press SEL to accept the setting,
or PGM to exit the setting without
change.
• Press PGM once or twice to exit
Programming mode.
If the Prescaler or the Reset Mode or the Batch Mode are changed, the new
configuration will not be fully effective until after exit from Program mode, AND THEN
AFTER a Reset.
Decimal Point
The decimal point can be in one of three positions, or off.
Prescaling
A multiplying or dividing factor can be used. If a multiplying prescaler of n is used, the
counter will count: 0, n, 2n, 3n etc. If a dividing prescaler of n is used, the counter will
increment or decrement on every nth input pulse.
Input Mode
See Input Modes.
Batch Mode
See Count Modes.
Reset Mode
See Auto Reset and Count Modes
Inhibit
See Front Panel.
Auto Reset
See Auto Reset and Count Modes
P1 and P2 Relays
See Relays
* Auto Reset On and P1 Relay Latched cannot be set together.
** In Batch mode, P2 Relay cannot be set to Pulsed.
LCD Backlight:
can be on, off, or turn on for 30 seconds when a button is pressed.
6
Main menu
Decimal Point menu
Prescaling menu
Input Mode menu
Batch Mode menu
Reset Mode menu
Inhibit menu
Auto Reset menu
P1 Relay Condition menu
P1 Relay Type menu
P1 Relay Safe State menu
P2 Relay Condition menu
P2 Relay Type menu
P2 Relay Safe State menu
LCD Backlight menu
Exit Programming mode