Publicité
English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate
handshower
tub filler
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• Protection against backflow is provided by check
valve and an automatically resetting diverter.
• This trim is for use with rough #10452181 (not
included). The rough must be installed and the
finished floor surface completed and made
watertight.
• This showerhead is for use with an automatically
compensating valve rated at 1.5 GPM (5.7 L/min)
or less.
2
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
2.0 GPM
5.3 GPM
• This unit is not anti-scald. If required by local code,
• To prevent scald injury, the maximum output
• Keep this booklet and the receipt (or other proof
install in combination with an approved remote
pressure balance valve or other approved device.
temperature of the shower mixing valve must be no
higher than 120°F. In Massachusetts, the maximum
output temperature can be no higher than 112° F.
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicité
