AENO GS1 Mode D'emploi page 7

outlet. Press the power button (6): the blue light (7) will light up, the red light (8)
will blink. Wait about 35 seconds for the steam to build up. Quiet crackling
during heating is allowed. The device is ready for operation when the red
indicator (8) is lit steadily. Place the item to be steamed vertically or
horizontally. Select the steam mode using the "+/-" button (9). Point the
steamer head away from yourself and those present, release the first batch of
steam, point the steamer head at the surface to be steamed. Start steaming by
pressing steam button (10). Press the steam button (10) again to stop steaming.
Press the power button (6) to turn the device off. Drain the remaining water
from the water tank.
Steam modes (adjustable with the "+/-" button (9)):
 low (one indicator light (8) of steam mode is on) – delicate fabrics/light
wrinkles;
 medium (two indicators (8) of steam mode are on) – everyday clothes made
of cotton, polyester/medium creases;
 high (three indicators (8) of steam mode are on) – heavy fabrics/strong
wrinkles.
WARNING! When using the device for the first time, check the operation of the
device on old clothing: it is possible that dust accumulated in the device during
production and transportation.
Note: For better steaming, it is recommended to use the brush head (4). Install
the brush head only on the unit when it is turned off and cool.
Auto Power Off Mode
If there is no operation in 15minutes, the power supply is automatically turned off.
Self-cleaning mode
For information on self-cleaning mode, see the full user manual at aeno.com..
Troubleshooting
 The steamer is not heated. Possible causes: the device is not turned on or not
connected to the power supply. Solution: Make sure that the unit is turned
on, the power plug is connected to the socket outlet, and the socket outlet
aeno.com/documents 7