AENO GS1 Mode D'emploi page 6

ENG The AENO GS1 garment steamer is designed to remove creases and
wrinkles in fabric, improve the appearance of different types of fabric using a
powerful steam jet.
Specifications
Voltage: AC 220–240 V; Frequency: 50/60 Hz. Power: 1500.0 W. Dimensions
(length × width × height): 201 mm × 128 mm × 293 mm. Water tank volume:
0.25 l. Steam modes: 35 g/min (high), 30 g/min (medium), 15±3 g/min (low).
Steam temperature: up to +160 °C.
Package Contents (Fig. A)
AENO GS1 steamer (1), brush head (4), measuring cup (5), quick start guide,
warranty card.
Limitations and Warnings
WARNING! The device connected to the mains is live even after it has been
turned off by the power button (6); unplug it immediately after use, before
cleaning, filling and emptying the water tank (2).
Do not allow the body of the steamer or the power cord to come in contact
with water. Do not leave the device plugged in unsupervised. Do not allow
children to use or play with the device. Do not turn on a damaged device. Use
the device indoors only. Unplug the device by holding the power plug, not the
cord; do not use an extension cord. The working surface of the steamer head
gets hot during operation, do not touch hot surfaces. Do not point the nozzle
at people. Never steam clothes on a person. Check the care label before
steaming. Use only distilled water.
Before the first use
Unpack the device. Place it on a stable horizontal surface without plugging it
in. Fill the water tank as shown in figure C. It is recommended to use the
measuring cup (5) provided for filling the device.
Operating the device
Connect the device to the mains by inserting the power plug into the power
6 aeno.com/documents