Lcd Screen - Sony HANDYCAM DCR-IP1E Mode D'emploi

Symptom
The remaining tape indicator is not
displayed.
A cassette label is not recorded.

LCD screen

Symptom
Indicators or messages are displayed
in a language you do not understand.
An unknown picture appears on the
screen.
An unknown indicator appears on the
screen.
The buttons do not appear on the
touch panel.
The buttons on the touch panel do not
work correctly or do not work at all.
Recording
If you are using a "Memory Stick Duo" for recording, refer also to the "Memory Stick Duo" section.
(p. 89)
Symptom
The tape does not start when you
press START/STOP.
Cause and/or Corrective Actions
cSet [
REMAINING] to [ON] on the
always display the remaining tape indicator. (p. 69)
cSlide the write-protect tab to hide the red mark. (p. 96)
Cause and/or Corrective Actions
cSet LANGUAGE to the desired language. (p. 20)
• The camcorder is in DEMO MODE. (The DEMO MODE is
automatically displayed when you leave the camcorder for 10 minutes
after setting the POWER switch to the CAMERA-TAPE mode without
inserting a cassette or "Memory Stick Duo.") Touch on the LCD screen
or insert a cassette or "Memory Stick Duo" to cancel DEMO MODE.
You can also set [DEMO MODE] to [OFF] on the menu. (p. 61)
cRefer to the indication list. (p. 113)
cTouch the LCD panel lightly.
cPress DISPLAY/BATT INFO (or DISPLAY on the Remote
Commander). (p. 43)
cAdjust the screen (CALIBRATION). (p. 104)
Cause and/or Corrective Actions
cSlide the POWER switch repeatedly to select the CAMERA-TAPE
mode. (p. 16)
cThe tape has reached the end. Rewind it, or insert a new cassette.
cSlide the write-protect tab to hide the red mark or insert a new cassette.
(p. 96)
cThe tape is stuck to the drum due to moisture condensation. Remove the
cassette and leave your camcorder for at least 1 hour, then reinsert the
cassette. (p. 103)
(STANDARD SET) menu to
,continued
Troubleshooting
87