Maintenance Tips For Users; Cleaning And Disinfektion - B+B Taiga Mode D'emploi

Taiga
| Electric Wheelchair
Electrical system
Main fuse :
Battery :
Batterry charger :
Motor:
Controller:
Lights:
Ambient conditions
Temperature :
Air humidity :
Storage conditions
Temperature :
Air humidity :
Equipment
Frame:
Seat and back frame:
Pad materials:
Brake:
Operating forces
Joystick:
Buttons on the control
panel:
Disconnecting the drive
mechanisms:
76
50 A
maintenance-free lead acid battery
2 x 12V / 80Ah
24V DC 8A
2 x 24V / 600W / 4400 rpm
PG Drive VR-2, R-Net 90A
headlights and rear lights according to
the German traffic regulations [StVZO]
0 - 50 °C
20 - 80 %
-20 - 60 °C
45 - 60 %
Aluminium, powder-coated
Steel, painted
flame-resistant, tested according to
EN1021-1/2
automatic braking system
Electromagnetic engine brake
according to the German traffic regulations
[StVZO]
approx. 1 N
approx. 1 N
> 60 N

6. Maintenance tips for users

6.1. Cleaning and disinfection
Make sure that the wheelchair is switched off before starting to clean
it.
• The frame sections and panels of the wheelchair can be cleaned
with a moist cloth. You can use a mild detergent for more stubborn
dirt.
• The wheels can be cleaned with a wet synthetic fiber brush (do not
use a wire brush!)
• The seat, seat back and arm rests can be cleaned of dust and minor
dirt with a damp cloth. Do not use aggressive cleaning agents,
because they may attack the surface of the material. The cushions
can be washed with warm water at 40°C and disinfected with a
standard disinfectant.
• Please note that electrical and electronic components must not
come into contact with water unnecessarily.
Caution! Do not use high pressure cleaners or
steam cleaners.
Bischoff & Bischoff GmbH | 01.06.2019
Taiga
Electric Wheelchair |
77