Elektronic Footrests; Seat - B+B Taiga Mode D'emploi

Taiga
| Electric Wheelchair
3.5.2 Electronic footrests
Length of lower leg supports
• The lower leg supports can be adjusted from 420 - 580 mm.
• To do so, loosen the two allen screws.
• Adjust to the desired height (fig. 05).
• Tighten the screws again.
• Use medium-strength Loctite to lock screws in place.
05
Angle of footrest
• The angle of the footplate is fully adjustable.
• Undo the screw to the side of the footplate.
• Adjust the footplate to the desired angle (fig. 06).
• Tighten the screw again.
• Use medium-strength Loctite for fixation.
06
Height of the calf pad
• The height of the calf pad is adjustable.
• Undo the screw to the side of the footrest.
• Adjust the calf pad to the desired height (fig. 07).
• Use medium-strength Loctite for fixation.
07
56
Make sure there is an appropriate distance between
footrests and the ground.

3.5.3. Seat

Seat with (mechanical)
• The seat with can be adjusted in three steps from 415 mm to 515
mm.
• Ensure that the wheelchair is switched off.
• Remove the attachment parts such as the leg rests, side parts, back
pad and seat pad.
• Detach the Velcro straps of the back rest cover (mechanically).
• You first adjust one half of the seat (left or right) and then the
other
• For each side, you must loosen two fastening screws under the seat
(fig. 08) and remove two Allen head screws from the back rest (fig.
09).
• Move the seat half to the desired width. Markings on the seat (fig.
10) serve as orientation aids. Shift the seat and back rest equally.
• Secure the screws to the back rest and tighten them and the
fastening screws under the seat. Repeat the procedure with the
other half of the seat
• You can pull the Velcro straps of the back rest taut again and
reattach all other attachment parts.
Ensure that both halves of the seat are adjusted
equally.
Bischoff & Bischoff GmbH | 01.06.2019
Taiga
Electric Wheelchair |
08
09
10
57