Hansgrohe Croma Select E Multi Wallbar Set 049410 Serie Instructions De Montage / Mode D'emploi / Garantie page 2

English
Technical Information
Max. flow rate
04941xx0, 04939xx0
04790xx0, 04940xx0 1.75 GPM (6.6 l/min)
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• The screws and anchors included with this set
are suitable for use in a tile or other solid surface
wall. They are not suitable for use in an acrylic
or fiberglass shower enclosure. Please contact
the manufacturer of the enclosure regarding
recommended mounting locations, reinforcement
requirements, and mounting hardware.
• This unit does not include a wall supply. It must
be used with Hansgrohe model 27458xx3
or another approved supply that complies
with ASME A112.18.1/CSA B125.1 including
ASME A112.18.3.
• To prevent scald injury, the maximum output
temperature of the shower mixing valve (not
included) must be no higher than 120°F
(49° C). In Massachusetts, the maximum output
temperature can be no higher than 112°F
(44° C).
2
2.5 GPM (9.5 l/min)
• 04941xx0, 04939xx0
showerhead is
compensating valves rated at 1.9 GPM
(7.2 l/min) or less.
• 04790xx0, 04940xx0
showerhead is
compensating valves rated at 1.3 GPM
(4.9 l/min) or less.
The wallbar is intended to hold a
handshower. Do not use it as a grab
bar. If a grab bar is required, install one
separately.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
only:
for use with automatic
only:
for use with automatic
This
This