Wilo Stratos MAXO-D 32/0,5-12 Notice De Montage Et De Mise En Service page 151

Installation and operating instructions Wilo-Stratos MAXO/-D/-Z
Put into operation
4
In the setpoint editor , the setpoint is shown.
Open the Home screen to quickly access the menu and adjust the setpoint. For this pur-
pose, press the operating button. The frame of the variable setpoint turns yellow which
indicates that it has been activated. The setpoint is changed by turning the operating
button right or left. The changed setpoint is confirmed by pressing the operating but-
ton again. The value is transferred to the pump and the focus returns to the Home
screen.
Pressing the Back button
and retains the old value. The focus returns to the Home screen.
NOTICE
Setpoint adjustment is not possible when Dynamic Adapt plus is active.
NOTICE
Pressing the context button
further settings.
In the operating data and measurement area
(e.g. current duty point) and other measured values are displayed.
In the "Active influences" area
one active EXT. OFF function) are displayed.
Possible "Active influences":
Sym- Information Meaning
bol
Peak-load operation
Solid pump symbol: Motor running on this side of the pump.
The graphic display has been installed on the left.
Main/standby operation
Solid pump symbol: Motor running on this side of the pump.
The graphic display has been installed on the left.
Pump continues to run in the configured control mode
without additional influences.
Override OFF Override OFF active.
Pump is switched off with maximum priority. The pump is
stationary.
Indication of activating override source:
1.
2.
MAX override active.
Pump running at maximum output.
Indication of activating override source:
1.
2.
MIN override active.
Pump running at minimum output.
Indication of activating override source:
1.
2.
MANUAL override active.
Pump running in control mode defined for MANUAL with a
setpoint adjusted for MANUAL.
during setpoint adjustment discards the changed value
will display additional context-related options for
7
, important operating parameters
5
, influences that currently influence the pump (e.g.
If not otherwise indicated: Override caused by request
from HMI or CIF module
DI1/DI2: Override caused by request via binary input.
If not otherwise indicated: Override caused by request
from HMI or CIF module
DI1/DI2: Override caused by request via binary input.
If not otherwise indicated: Override caused by request
from HMI or CIF module
DI1/DI2: Override caused by request via binary input.
en
151