Publicité
Les langues disponibles
Les langues disponibles
Configuring
Baud
4 0
8
1
n
T 3
Time
d
1
8
A
r
n
Y
E
t
2 5
Tref25
S/
o
d
C
n
0 0
9
Day.Month
10
Configuring
Note
You can leave the configuration menu at any time with <M>. The parameters
already changed are stored.
Procedure for configuring (factory settings appear in bold typeface):
Switch off the measuring instrument.
While pressing the <M> key, press <
Select the required Baud rate with <L> <M>.
0
Selection: 1200, 2400, 4800, 9600 Baud.
Then press the <RUN/ENTER> key.
Set the required calibration interval with <L> <M>.
Selection: 1... 180... 999 d.
Then press the <RUN/ENTER> key.
0
Switch the automatic measuring range selection AutoRange on/off with
<L> <M>.
Selection: YES (On), no (Off).
Then press the <RUN/ENTER> key.
S
ARng
Switchover the reference temperature of the conductivity with <L> <M>.
Selection: 25 °C (Tref25) and 20 °C (Tref20).
Then press the <RUN/ENTER> key.
Switch the units of the conductivity display on/off with <L> <M>.
Selection: S/cm, MΩ
cm
Then press the <RUN/ENTER> key.
Select the date and time step-by-step with <L> <M>. In between, press
4
the <RUN/ENTER> key each time.
When the last <RUN/ENTER> key has been pressed, the instrument
changes to the last active measuring mode.
>.
⋅
cm.
Cond 3300i/3400i
Publicité
