Uline H-2533 Mode D'emploi page 5

ATTACHING HANDLE
Figure 10
1. Place the door handle (15) on the right hand door
and fasten with two slotted bolts and lockwashers.
(See Figure 10)
2. Turn the handle to the open position (parallel to the
ground) and hook the lock bars (16) to the locking
cam (17). (See Figure 11)
3. With the handle still in the open position, place the
locking cam (17) over the square shank of the door
handle. The locking cam must be facing downward
as shown. (See Figure 11)
4. Hold the lock bars in position while sliding the lock
bar guides (18) through the door slots over the ends
of the lock bars. (See Figure 11)
5. Place cotter pin (19) through the hole of the square
shank. (See Figure 12)
PAGE 5 OF 15
ASSEMBLY INSTRUCTIONS CONTINUED
15
1-800-295-5510
uline.com
Figure 11
18
16
17
Figure 12
19
16
18
0723 IH-2533