Uline H-2533 Mode D'emploi page 3

ASSEMBLING CABINET
1. Place the back panel (1) on a protected surface.
The bottom flange should be facing upward.
2. Attach the left side (2) and right side (3) to the back
panel by placing flange around the back and
bolting the back and sides together with seven
bolts and nuts on each side. Be sure that the lances
on all shelf adjustment strips point in the same
direction. (See Figure 1)
Figure 1
3. Insert bolts into the outside holes on the sill (4),
placing two on each end (See Inset A). Attach the
nuts, but do not tighten. Next, insert the loose bolt
heads on the sill into the large end of the keyhole
slots at the bottom of each side panel. Slide the bolt
heads securely into the smaller end of the keyhole
slot, and tighten the four nuts securely. (See Figure 2)
Figure 2
4
PAGE 3 OF 15
ASSEMBLY INSTRUCTIONS
2
1
3
Inset A
4. Insert the shelf (5) into the third from top position
on the shelf adjustment strips. Do this by inserting
the shelf edges into the lances on all four strips. Be
sure the channeled edge of the shelf is toward the
cabinet front. (See Figure 3)
Figure 3
5. Attach the top (8) to the unit by sliding the outer
flange over the back of the unit and the side flange
on the side panel of the unit. The threaded studs
should go through the holes in the top flange of the
side and fasten with three nuts. Attach the back to
the top using four bolts and nuts. (See Figure 4)
Figure 4
5
Inset B
0723 IH-2533
8