Uline H-5799 Instructions D'installation

H-5799, H-5800
SEMI-RECESSED
FIRE EXTINGUISHER
CABINET
TOOLS NEEDED
Drill Phillips Head Screwdriver
Plexiglass Window x 1
MOUNTING DIAGRAM (TOP VIEW)
ATTACHMENT
SCREW
CABINET
FRAME
1⁄"
1. Remove everything from inside cabinet.
2. Build a frame around the cabinet inside the wall to
ensure structural stability.
PAGE 1 OF 6
1-800-295-5510
uline.com
Handle x 1
MOUNTING
FRAMING
TUB
DRYWALL
DOOR STOP
HINGE
2⁄" OR 3"
TRIM
DOOR
PARTS
Latch x 1
NOTE: On load-bearing walls, the studs must
be doubled on either side of the cabinet tub.
If a stud must be cut to install the cabinet, a
load-bearing header must be installed in the
cabinet tub.
3. Place cabinet in position and mark location of
attachments on studding using holes in cabinet as
marking guides. Cabinet must be attached by at
least four points, two of which must be in studs.
4. Remove cabinet and drill 5/32" holes through studs
at marked points. Install plastic wall anchors in no
more than 2 places if needed. For masonry walls,
install expansion shields in wall at marked points.
5. Place cabinet in position and attach with universal
#10 x 2½" self-drilling screws (not included).
6. Check cabinet door assembly for binding or
gapping and shim as necessary.
Para Español, vea páginas 3-4.
Pour le français, consulter les page 5-6.
Flat-End Bolt x 2
Screw x 6
Bracket x 4
0821 IH-5799