Publicité
Les langues disponibles
Les langues disponibles
4.3 START OPERATIONS
Machine is not designed to be used by people (also children) whose
physical, sensory or mental capabilities are reduced. Also people without
experience or knowledge of the machine can't use it.
People, described above, can use this machine only if there's someone,
responsable of their safety, which watches them and gives them
instruction regarding the use of the machine.
Children must be watched in order to be sure they don't play with machine.
This machine is designed in order to be used by experienced users or
trained in shops, light industry and farms.
People without experiences can use this machine only for a commercial
use.
PRE-START CHECK
Caution: before proceeding to start up, check that all the cover panel be
located in the proper position and locked with fastening screws.
1. Connect the internal unit to the outdoor one. There are 4 connectors. Two for water-glycol
(connect the same pipe N°1 with N°1, N°2 with N°2) (C); one for drained condensed water (D)
which is sent to outdoor unit, one which is the electric power supply for outdoor motor-fan (A) and
one for the protection heart connection, (B).
Always connect the outdoor unit with the ground wire!!
2. Insert the socket in an earthed plug.
3. Select desired fan speed
4. Select desired room temperature
5. Move the main switch from OFF position to Cool or Fan position.
The machine should start. If it's set in Cool function and the room temperature is higher than the set
temperature, the compressor after approx. 3,5 minutes starts to work. Led RUN is blinking while compressor is
waiting, it's on when compressor is running.
If the room temperature is lower than the set, machine remains in ventilation but it does not make cool (the
compressor remains off and only the fan is on). Led RUN is off. If room temperature is lower than 18°C,
25
DE
Publicité
