Publicité
Les langues disponibles
Les langues disponibles
3. TECHNICAL DATA
Below is an example of the nameplate:
The nameplate attached to the inside or rear of the appliance (depending on the model) includes the entire information
specific to your appliance.
We recommend that you make a note of its serial number in this booklet prior to installation, so that you can refer to it later
(technical work, request for assistance, etc.).
Once the appliance is installed and loaded, access to it is not so easy.
CAUTION: no assistance can be provided without this information.
4. INSTALLATION INSTRUCTIONS
Before using this appliance
• Remove the exterior and interior packing.
• Before connecting the appliance to the power source, let it stand upright for approximately 24 hours. This will reduce the
possibility of a malfunction in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• When disposing your appliance, please choose an authorized disposal site.
• Use two or more suitably qualified people to move and install the appliance. Failure to do so can result in back or other
injury.
• Place your wine cooler on a position that is strong enough to support it when it is fully loaded. To level your wine cooler,
adjust the front leveling leg at the bottom of the wine cooler.
• Adequate ventilation is required, do not block the front air outlet.
• Not designed for placement in adage or basement.
• The appliance is for indoor use only.
• This wine cellar is designed for free-standing or built-under installation.
• Connect the cellar to a single socket and be careful to support it, so that your wine cellar is perfectly level (use of a spirit
level is recommended). This will prevent any movement due to instability, causing noise and vibration, and will ensure that
the door seals perfectly.
39
Publicité
