Publicité
Les langues disponibles
Les langues disponibles
8
installation instructions
• The safety during use can only be guaranteed when the hob is installed correctly and according to the regulations. The
installer is responsible for any damage caused by a faulty installation.
• The gas connection must comply with the national and local safety regulations. The gas connection must be made by q
qualified installer.
• The electrical connection must be made by a qualified electricien. This person is aware of the national and local
regulations the installation must comply with.
• The appliance falls under protection class I and can only be used in combination with a grounding conductor connection.
The manufacturer accepts no responsibility for any malfunction or damage caused by incorrect electrical installations.
•
The appliance must be connected to a fixed installation and the means of disconnecting it from the fixed installation
must be installed according to the installation instructions.
• The connection cable must hang freely. Do not tie the power cable or pass it along sharp edges. If there is an oven
installed below, pass the cable along the rear corners of the oven to the connection box. It must be positioned so that it
does not touch any of the hot parts of the hob or the oven.
• The connection point, the wall socket and/or plug must always be accessible.
• The worktop into which the hob is fitted should be flat. Follow the instructions of the manufacturer of the worktop.
• Damage caused by incorrect connection, incorrect use or incorrect fitting is not covered by the guarantee.
• Attention: any change to the appliance's interior, including fitting and changing the power cable, must only be performed
by a qualified electricien.
SPACE AROUND THE HOB
Sufficient clearance around the hob is essential for a safe use of the hob. Check that there is sufficient clearance.
Dimensions
IKG6024WGZWA
A
B
min. 700
min. 600
C
D
min. 400
min. 200
21
English
•
Publicité
