Publicité
Les langues disponibles
Les langues disponibles
Bend the bearing frame 7.17 according to the
drawing and push a sleeve 7.18 over the ends.
Fig. bearing frame
Now make the searchlight from parts 7.12, 7.13
and 7.14 and attach it to the roof. Also the fog
horn 7.11.
Fig. searchlight and fog horn
On the roof still attach the handrail 3.26 and the
buoys 6.20.
Fig. handrail and buoys
Make the life ring holder 7.16 according to drawing
R from 3 * 0,3 mm brass strips. Paint the holder
and lifering 7.15 and attach to the rear wall of the
wheelhouse.
Stand Mai 2019
M
T
.com
Seite 21
Fig. lifering holder and lifering
Now, install the shear boards. Drill 1.5 mm for the
split pin in the recess of the net gallows. Attach the
blocks 4.11 with the split pins 4.12 to the net gal-
low.
Fig. roller block
Roll up the lines 6.26 onto the drums of the net
winch. Install an S-hook 7.33 and a loop after the
winch so that the superstructure can be removed.
Guide the line through the king pulley to the roller
block and over the roller block at the net gallows
and attach the trawl board at the end. Guide the
second line over the king pulley to the second
pulley block at the bulwark, then over the pulley in
the rear net gallows to the pulley block. At the end,
attach the second shear board.
Fig. attaching the lines
In the last step attach the sail and the fake net.
Make the sail 7.22 from the sail material in the
fittings set according to the drawing. Transfer the
©
Krick Modelltechnik Knittlingen
Publicité
