Hilti SR 6-A22 Mode D'emploi page 16

▶ Do not use the product to cut pipes that still contain liquids.
▶ Do not saw into unknown materials.
3.4 Lithium­ion battery status display
The Li-ion battery state of charge and malfunctions of the power tool are
indicated by the display on the Li­ion battery. The Li­ion battery state of
charge is displayed after pressing one of the two battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks.
1 LED blinks, the power tool is not
ready for use.
4 LEDs blink, the power tool is not
ready for use.
Battery state of charge cannot be displayed while the control switch is
pressed and for up to 5 seconds after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given
in the Troubleshooting section.
3.5 Items supplied
Reciprocating saw, operating instructions.
Other system products approved for use with this product can be found at
your local Hilti Store or at: www.hilti.group | USA: www.hilti.com
4 Technical data
Rated voltage
Weight including battery B22⁄8.0
Stroke rate
Stroke length
Blade holder
Storage temperature
Ambient temperature for operation
10 English
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
State of charge: 10 % to 25 %
State of charge: < 10 %
The battery has overheated or is
completely discharged.
The power tool is overloaded or has
overheated.
2186515
*2186515*
SR 6-A22
21.6 V
4.1 kg
(9.0 lb)
2,600 /min
32 mm
(1.3 in)
0.5 in
−20 ℃ ... 70 ℃
(−4 ℉ ... 158 ℉)
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)