Bosch 00634736 Manuel D'installation page 5

5. Insert the right corner piece as shown (see Figure 3:
Right side corner cover placement, first step).
Figure 3: Right side corner cover placement, first step
6. Rotate the corner cover so that the corner cover is flat
and the round hole in the corner cover aligns with
hole 1 (see Figure 4: Right side corner cover
placement, second step).
Figure 4: Right side corner cover placement, second step
7. Insert screw (saved or from the kit) into hole 1 and
lightly tighten (see Figure 5: Screw placement).
Figure 5: Screw placement
English 4
8. Press up on the corner cover at the arrow (see Figure
6: Tighten screw) while finishing the tightening of the
screw.
Figure 6: Tighten screw
9. Repeat the previous steps 5 through 8 for the left side
corner cover.
10. If necessary, have a qualified service technician
reattach electrical or gas connections.
11. Slide the range back into position. If necessary, to
avoid scratching the countertop, adjust the height of
the range by adjusting the range feet (see Figure 7:
Adjusting range height). Be sure to engage the anti-tip
bracket. See the Tip Over Hazard Warning earlier in
this instruction and also in the Gas Slide-In Range
Installation Manual.
Figure 7: Adjusting range height