Hilti TE 3-ML Mode D'emploi page 12

Drilling diameter range in
concrete/masonry (hammer drill bit)
Drilling diameter range in wood (solid)
Drilling diameter range in metal (solid-
head drill bit)
Storage temperature
Ambient temperature for operation
4.2 Noise information and vibration values determined in accordance with EN 60745
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure. The data given represents the main applications of the power tool.
However, if the power tool is used for different applications, with different accessory tools, or is poorly
maintained, the data can vary. This can significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This can significantly reduce exposure over
the total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: maintaining the power tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise emission values determined in accordance with EN 60745
Sound (power) level (L
WA
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration (vector sum of three directions), measured in accordance with EN 60745
Chiseling (a )
h, Cheq
Hammer drilling in concrete (a
Drilling in metal (a )
h, D
Uncertainty for the given vibration value (K)
5 Operation
Fitting the side handle
CAUTION
Risk of injury! The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the tool.
CAUTION
Risk of injury! Loss of control over the rotary hammer drill.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping
band is engaged in the groove in the tool.
Fitting/removing the drill bit or other accessory: SDS quick-release chuck
Use of unsuitable grease may cause damage to the product. Use only the
recommended grease supplied by Hilti.
TE 3-ML
Fitting/removing the drill bit, chisel or other accessory: Three-jaw chuck
Drilling without hammering
Screwdriving
Drilling with hammering action (hammer drilling)
6 English
Printed: 07.01.2019 | Doc-Nr: PUB / 5279057 / 000 / 05
TE 3-ML
4 mm ... 28 mm
1.5 mm ... 20 mm
1.5 mm ... 13 mm
−20 ℃ ... 70 ℃
−17 ℃ ... 60 ℃
)
)
WA
)
pA
)
pA
)
h, HD
TE 3-CL
4 mm ... 28 mm
1.5 mm ... 20 mm
1.5 mm ... 13 mm
−20 ℃ ... 70 ℃
−17 ℃ ... 60 ℃
101 dB(A)
3 dB(A)
90 dB(A)
3 dB(A)
13.9 m/s²
15.1 m/s²
3.0 m/s²
1.5 m/s²
2121691
*2121691*
3
4
5
6
6
6