Nikon AF-S VR Nikkor 300mm f/2.8 G IF-ED Nano Crystal Coat VR Manuel D'utilisation page 20

To take pictures at the memorized focused distance, (1) press the Focus operation
button, or (2) continue to lightly depress the shutter release button to recall the
memory, then fully depress the shutter release button.
Note 2: If the distance scale ring turns from right to left about 10 times when setting, and at the
same time one short beep and three long beeps sound, perform Memory set again.
■Using AF start
(Operation varies depending on cameras in use. See page 16.)
En
1 Set the Focus mode switch ) to "M/A". (Fig. F)
2 Set the Focus operation selection switch , to "AF-ON". (Fig. I)
3 Autofocus starts while you are pressing the Focus operation button 4. (Fig. C)
4. Vibration reduction mode
■Basic concept of vibration reduction
When taking pictures
When taking panning shots
When taking pictures from
a moving vehicle
When taking pictures using a tripod
20
Vibration reduction using a tripod
Camera shake
Strength of vibrations
Set the vibration reduction mode switch to "NORMAL".
Set the vibration reduction mode switch to "ACTIVE".
(See page 16 for usable cameras.)
Panning shots
Set the vibration reduction mode switch to
either "NORMAL" or "ACTIVE".
Set the vibration reduction mode switch
to "NORMAL".
Set the vibration reduction mode switch
to "ACTIVE".
Set the vibration reduction mode switch to
either "NORMAL" or "ACTIVE".
Camera shake
when taking
pictures from a
moving vehicle