Bosch KGN392IDA Notice D'utilisation page 43

Fault
The temperature in the
freezer section is too warm.
A warning signal sounds.
The 6 alarm button lights up.
The light does not function.
Controls have reduced
luminosity.
Displays do not illuminate.
Appliance is not cooling,
temperature display and light
are lit.
Possible cause
Appliance opened
frequently.
The ventilation openings
have been covered.
Large quantities of fresh
food are being frozen.
Fault - the freezer section is
too warm!
Appliance is open.
Ventilation openings are
covered up.
Too much food was placed in
the freezer at once.
The LED light is defective.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
When the appliance is not
used for some time,
the display on the fascia
switches to energy saving
mode.
Power failure; the fuse has
been switched off; the mains
plug has not been inserted
properly.
Showroom mode is
switched on.
Remedial action
Do not open the appliance unnecessarily.
Remove obstructions.
Do not exceed the freezing capacity.
To switch off the warning signal, press 6 alarm
button.
Close the appliance.
Ensure that there is adequate ventilation.
Do not exceed the freezing capacity.
When the fault has been eliminated, the alarm
button goes out shortly afterwards.
See chapter "Light (LED)" section.
When the appliance is closed and opened,
the light is on again.
As soon as the appliance is again used, e.g.
the door is opened, the display switches back
to normal illumination.
Connect mains plug. Check whether the power
is on, check the fuses.
Hold down temperature selection button
fig. "/2 for 10 seconds until
an acknowledgement signal sounds.
After a short time check whether your
appliance is cooling.
en
43