emerio FN-126821 Mode D'emploi page 6

To use the remote control, please note:

2 x AAA batteries are required.

Ensure that the batteries are inserted into the battery compartment in the correct direction.

Do not mix battery types.

If replacement required, ensure that both batteries are changed simultaneously.

If it is not in use for a long time, please take the batteries out of the remote control.

When operation, point the remote control towards the LED display at the front of the fan and ensure that
there is no obstruction on the path of the signal.

Handle the remote control carefully, do not drop or throw it.
ASSEMBLY INSTRUCTIONS
** Please assemble correctly by the following order when using.
1. Assembly of the stand
Rotate off the washer and the L screw.
⚫
To assemble a standing fan, put the lower column into the base and fix it by screwing tightly the washer and
⚫
the L screw at the back of the base. Put the upper column and control box above and use column fastening
bolts to tighten the connection.
To assemble a desk fan, directly put the control box into the base and fix it by screwing tightly the washer
and the L screw.
2. The whole assembly

Remove the black protective sleeve from the motor shaft. Rotate off the Guard fastening screw.

Align and place the rear guard onto the motor housing. Fix it by tightening the guard fastening screw.

Place the fan blade onto the motor shaft by matching the groove with the shaft pin. Fix the blade by
tightening the blade fastening screw. Check that the fan blade can rotate freely by turning it with your
hand.
Shaft pin

Put the front guard against the rear guard. Align the guard rims and push the two guards together.
Close the circlip and fix it by the provided screw.
All manuals and user guides at all-guides.com
Protective sleeve
- 5 -