Publicité
Les langues disponibles
Les langues disponibles
7. Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the cylinder valve
outlet that is provided with the cylinder valve.
Other types of cap or plugs may result in leakage of propane.
CYLINDER SPECIFICATIONS:
When purchasing or exchanging a cylinder for your gas grill, it must be constructed and marked in accordance with the specifications
for LP gas cylinders of the U.S. Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA-B339 Cylinders,
Spheres and Tubes for Transportation of Dangerous Goods; and Commission, as applicable; and provided with a listed over-filling
prevention device (OPD), and provided with a cylinder connection device compatible with the connection for outdoor cooking appliances.
Provide with a listed overfilling prevention device.
Provided with a cylinder connection device compatible with the connection for outdoor cooking appliances
The cylinder must also be equipped with:
A shut-off valve terminating in a Type 1 gas cylinder valve outlet,
A Type 1 valve that prevents gas flow until a positive seal is obtained,
An arrangement for vapor withdrawal,
A collar to protect the cylinder shut-off valve.
A safety relief device having direct communication with the vapor space of the cylinder,
A listed over-filling prevention device (OPD),
A frosty cylinder valve indicates possible gas overfill. Close the LP valve and call your dealer immediately.
LP GAS CYLINDER (NOT SUPPLIED WITH THIS GRILL)
The LP cylinder is available for purchase at the same location the grill was purchased.
The LP (Liquid Propane) gas cylinder specifically designed to be used with this grill must have a 20 lb. (9.1 kg) capacity incorporating a
Type 1 cylinder valve and an over-filling protection device (OPD)
This grill is designed to fit Worthington, Manchester or SMPC brand 20 lb. (9.1 kg) cylinders. Other brand DOT cylinders may fit this grill
if the cylinder has similar dimensions of the top and bottom rings.
DO NOT connect this grill to an existing #510 POL cylinder valve with Left Hand threads. The Type 1 valve can be identified with the
large external threads on the valve outlet.
DO NOT connect to a propane cylinder exceeding this capacity.
DO NOT connect to a cylinder that uses any other type of valve connection device.
Other cylinders may be acceptable for use with the appliance provided they are compatible with the appliance
retention means and accompanied by illustration depicting the cylinder mounted to the appliance utilizing the
cylinder retention means and the point of
contact between the cylinder and the retention means
Cylinder size to be used
12" (30.5cm) in diameter by 18" (45.7cm) high
LP CYLINDER LEAK TEST
A leak test should be done each time a cylinder is refilled or exchanged. Do
not smoke or use any type of flammable material in the area during this leak test.
Do not use an open flame to check for leaks.
1. Test outside in a well ventilated area.
2. Use a paintbrush and a solution of 50% liquid soap and 50% water.
Do not use cleaning agents and they can damage the fuel supply parts.
3. Brush liquid onto areas highlighted with arrows.
4. Growing bubbles indicate a leak.
The gas pressure regulator provided with this outdoor cooking appliance must be used. This regulator is set for an outlet
Your regulator is equipped with a Q.C.C. Type 1 quick connect system. It will not allow gas to flow until a positive seal has been made.
It has a thermal element that will shut off the gas flow if the temperature reaches 240 degrees F (115 degrees C). It also has a
flow-limiting device that will restrict the flow of gas to 10 cubic feet per hour (0.28 cubic meters per hour).
Before each use, check the gas hose for excessive abrasion or wear, or cuts. Replace a hose assembly showing those signs with the
hose assembly specified in the p arts list before using the grill.
WARNING
CAUTION
pressure of 11 inches water column.
EN-3
Publicité
