Publicité
Les langues disponibles
Les langues disponibles
Please read and understand this manual carefully before using the automatic welding helmet.
•
Be sure that the dark shade of the lens in the welding helmet is the correct shade number for your
application.
•
This helmet and lenses are not suitable for "overhead"welding application, laser welding, or laser
cutting applications.
•
Welding helmets are designed to protect the eyes and face from sparks, spatter, and harmful
radiation under normal welding conditions.
•
This helmet will not protect against explosive devices or corrosive liquids. Machine guards or eye
splash protection must be used when these hazards are present.
•
Impact resistant, primary eye protection, spectacles or goggles that meet current ANSI
specifications, must be worn at all times when using this welding helmet.
•
Avoid work positions that could expose unprotected areas of the body to spark, spatter, direct and/or
reflected radiation. Use adequate protection if exposure cannot be avoided.
•
Check for light tightness before each use. Before each use, check that the protection plates are clean
and that no dirt is covering the sensors on the front of the lens.
•
Inspect all operating parts before each use for signs of wear or damage. Any scratched, cracked, or
pitted parts should be replaced immediately.
•
Do not make any modifications to either the welding lens or helmet, other than those specified in this
manual. Do not use any replacement parts other than those specified in this manual, unauthorized
modifications and replacement parts will void the warranty and expose the user to the risk of
personal injury.
•
If this lens does not darken when striking arc, stop welding immediately and contact a customer
service representative.
•
Do not immerse this lens in water, this model is not waterproof.
•
Do not use any solvents on any lens or helmet components.
•
The recommended operating temperature range for welding lens is -10°C–65°C (14°F–149°F ). Do not
use this device beyond these temperature limits.
•
Failure to follow these warnings and/or failure to follow all of the operating instructions could result in
severe personal injury.
Characteristics
47105 automatic welding helmet is equipped with a filter set that can become dark. The filter is transparent
before welding, so the operators may observe the work surface clearly. When striking arc, the filter darkens
automatically. When the welding light goes out, the filter will become transparent again. The switching
time from light to dark is about 0.08 ms.The switching time from dark to light may be set up within 0.1-0.9
seconds.
The helmet is equipped with continuous darkness-adjusting unit, so the operator may select an arbitrary
dark shade number ranging from 9-13.
47105 automatic welding helmet gives the operators permanent complete protection against UV/IR even
when transparent. The UV/IR protection level is up to DIN15 at all time. The power is provided by solar
cells and a replaceable battery.
The mask is equipped with 4 sets of photosensors to sense arc light. In addition, the mask is also provided
with an outer protection plate made of high polymer materials. The plate is wear-resistant, thermostable,
and has no dregs-sticking, thus a very long service life.
2
WARNING!
Publicité
