Electrolux EFLW317TIW Instructions D'installation page 11

5. Tighten by hand
until snug. Then
tighten each
supply connec-
tion another 2/3
turn with pliers.
Do not bend, kink or pinch water
inlet hoses.
6. Turn on the water
and check for
leaks.
Connecting drain and
electrical
1. Verify the
anti-siphon
disc is
in place.
2. Form a "U"
shape on
the end of
the drain
hose with
the hose pointed toward the drain.
Place the formed end in a laundry tub
or a standpipe and secure the drain
hose with the cable tie (provided in the
enclosure package) to the standpipe,
inlet hose, laundry tub, etc. so the hose
does not pull out from the force of the
water.
Cable Tie
Installation Instructions
Anti-Siphon Disc
Insert Less
Than 8.5"
(21.5 cm)
NOTE
The standpipe inside diameter must be
1-1/4" (3.2 cm) minimum. There must be
an air gap around the drain hose in the
standpipe. A snug hose fit can cause a
siphoning action.
IMPORTANT
Check to ensure the power is off at a
circuit breaker/fuse box before plugging
the power cord into an outlet.
3. Plug the power cord into a grounded
outlet.
WARNING
ELECTRICAL SHOCK HAZARD
Improper connection of the equipment
grounding conductor can cause an elec-
trical shock that may result in serious inju-
ry or death. Check with a licensed electri-
cian if you are in doubt as to whether the
appliance is properly grounded.
See Electrical System Requirements and
Grounding Requirements sections of this
instruction for additional information.
4. Turn on the power at a circuit breaker/
fuse box.
5. Carefully slide the washer to its final
position. Recheck for level and rock
corners for stability. See "Leveling
your washer" section. Remove and
discard door tape.
6. Read the Use & Care Guide provided
with the washer. It contains valuable
and helpful information that will save
you time and money.
7. Run the washer through a complete
cycle, checking for water leaks and
proper operation.
8. If you have any questions during initial
operation, please review the "Service
Prevention Checklist" in your Use &
Care Guide before calling for service.
9. Place these instructions in a location
near the washer for future reference.
NOTE
A wiring diagram and technical data
sheet are located under the washer top
panel, on top of the detergent dispenser
housing.
11