Philips PERFECTCARE PURE GC7600 Mode D'emploi page 11

Problem Possible cause
The appliance There is not enough water
does not produce in the water tank.
any steam.
You have not pressed the
steam trigger.
You have just installed a new
ANTI-CALC cartridge.
The ANTI-CALC cartridge
is not placed properly.
The appliance You have to replace the
beeps and less or ANTI-CALC cartridge.
no steam comes
out of the iron
when I press the
steam trigger.
storage
1 Switch off the steam generator and unplug it.
2 Pour the water out of the water tank into the sink.
3 Fold the supply hose.
4 Pass the loop of the supply hose behind the storage hook (1)
and insert it into the storage compartment (2). Push the rest of the
supply hose into the storage compartment (3).
5 Fold the mains cord and fasten it with the Velcro strip.
6 Specific types only: You can carry the appliance with one hand by the
handle of the iron when the iron is locked on the iron platform.
Troubleshooting
This chapter summarises the most common problems you could encounter
with the appliance. If you are unable to solve the problem with the
information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Consumer Care Centre in your country.
Solution
Fill the water tank beyond the MIN indication.
Press the steam trigger and keep it pressed when
you iron.
Press and hold the steam trigger for 10 seconds
until steam comes out.
Press down the ANTI-CALC cartridge until it locks
into position.
Replace the ANTI-CALC cartridge (see chapter
'IMPORTANT: Replacing the ANTI-CALC cartridge').
You can also use demineralised water or descaled
water from the IronCare. In that case, you need to
leave the exhausted cartridge in the compartment.
ENGLIsh
11