Publicité
Les langues disponibles
Les langues disponibles
Installation (continued)
9
Installing the lift rod
□
Slide the lift rod (V) through the faucet
assembly (A) until the knob rests on the faucet
assembly.
□
Push the pivot rod (Q) to the down position until
the stopper (K) is completely open. Press the
button (R) on the slip joint assembly (S) and
adjust the vertical rod (T) up or down and front
or back along the pivot rod (Q) until the vertical
rod (T) is in the correct position to engage with
the lift rod (V). Press lift rod (V) into the top of the
vertical rod (T) until it engages.
□
Operate the lift rod (V) up and down to verify that
the stopper opens and closes correctly.
A
K
Q S
V
T
R
Q
S
10
Remove the quick connector
□
If it is necessary to remove the quick connector
(1), squeeze the tabs (2) on the quick connector
and then pull down to disconnect.
Squeeze
R
8
Pull
2
down
1
Publicité
