Scheppach ABP2.0-20Li Traduction Des Instructions D'origine page 9

is a risk of fire if a charger for a particular type of
battery is used for another type of battery.
• The battery can be damaged by sharp objects
such as a nail or screwdriver or by external ap-
plication of force. The battery may short-circuit
and start burning, smoking, exploding or overheat­
ing.
Warning! This electric tool generates an electro­
magnetic field during operation. This field can im­
pair active or passive medical implants under certain
conditions. In order to prevent the risk of serious
or deadly injuries, we recommend that persons with
medical implants consult with their physician and the
manufacturer of the medical implant prior to operating
the electric tool.
Intended use
Please note that our equipment has not been de­
signed for use in commercial, trade or industri­
al applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
Remaining hazards
The machine has been built using modern technology
and in accordance with recognized safety rules.
Some hazards, however, may still remain.
• Electrical hazards exist when unsuitable electric
connections are used.
• Although having regarded all considerable rules
there may still remain not obvious remaining haz­
rds.
• Minimize remaining hazards by following the in­
structions in "Safety Rules", "Use only as author­
ized" and in the entire operating manual.
Technical data
Battery type
Nominal voltage
Capacity
Operating temperature
Weight
Use
Advice for a long battery service life
m CAUTION!
• Never charge batteries below 0 °C or above 40 °C.
• Do not charge batteries in environments with high
humidity or high temperatures.
• Do not cover the battery or the charger during
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
• Disconnect the charger mains plug after charging
During charging, the battery and the charger will heat
up. That is normal. Lithium­ion batteries do not have
the known "memory effect". Nevertheless, a battery
should be fully discharged before charging it, and the
charging process should always be fully completed.
NOTE
• Follow the battery charging instructions in the user
• Reduced operating durations after charging indi­
• If the batteries are not used for a while, store them
• Store the battery and the device separately from
Transport
The equivalent lithium content of the batteries includ­
ed in the delivery is below specified limits. Therefore,
the battery as an individual component, as well as
the power tool with its delivery contents, are not sub­
ject to national or international hazardous materials
regulations. These regulations may become relevant
when transporting several devices with lithium-ion
batteries, which then require particular safety meas­
ures (e.g. for the packaging). In this case, find out
about applicable regulations for the country of use.
m CAUTION! Do not use batteries with damaged
casings.
Disposal and recycling
m WARNING!
Do not dispose of batteries in household waste, in fire
or water. Do not open worn-out batteries.
Batteries should be collected, recycled or disposed of
in an environmentally friendly manner.
The equipment is supplied in packaging to prevent it
Lithium­Ion
from being damaged in transit. The raw materials in
20 V
this packaging can be reused or recycled. The equip­
2 Ah
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
0 - 40 °C
components must be disposed of as special waste.
0,4 kg
Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point. This
can occur, for example, by handing it in at an author­
charging.
the battery.
manual for the power tool or the charger.
cate a worn battery. The battery must be replaced.
partly charged in a cool place (10-25 °C).
each other.
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
GB 9