Operating Procedure - Toxic TX-400 Mode D'emploi

®

OPERATING PROCEDURE

After the amplifier has been installed and all connections have been made
carefully and secure, turn the radio on so that the amplifier is switched on
automatically. After a short power-on period, the amplifier reaches its full
performance.
Now turn up the volume slowly, using the volume control of the radio. If
there is no sound or only a distorted replay, switch off the radio immediately
- the amplifier will also switch off automatically - and check if all connections
have been made correctly.
HOW TO PROCEED IN CASE OF FAULTS
No function
The connection cable is not connected correctly (= terminals Batt/Gnd/
Rem). Ensure that all connections have electric and mechanic contact and
that the jacket has been removed. The fuse is defective - pay attention to
the correct value of a new fuse!
No sound
Speaker cables or speaker plugs are not connected correctly.
No sound / green LED shines
The plus and minus wires of the speaker cables have contact, thus
eliminate the short circuit.
If you use a 2 ohm speaker in stereo mode, a 4 ohm speaker in bridge
mode or tri-mode and the set is overloaded, then turn the gain control to
„min" until the operation is free of trouble.
One channel without function
The balance control is not in centre position, thus correct the position.
The speaker or its lead is defective, so check the speaker, lead and
connections.
27
© Toxic 2004