Installation Instructions - Toxic TX-400 Mode D'emploi

®
INTRODUCTION
Before installing the power amplifier please read this instruction manual
carefully. The instructions for mounting and connecting the set have to be
followed precisely. If necessary, a service centre should be consulted.
All connections for DC power, signal input and speaker outputs can be
carried out easily and safely by way of RCA and screwed terminals.

INSTALLATION INSTRUCTIONS

Please choose a mounting place without any direct weather influences.
Note that the amplifer generates heat so that a well ventilated place is
necessary. According to your car's construction, the set can be installed
under the seat or in the boot. In any case, the installation has to be made
very carefully in order to ensure the amplifier's full performance and
reliability.
Keep the wire connections as short as possible with sufficient dimensions in
order to minimise power losses and provide a higher audio output of the
system.
For safety reasons route all power and speaker wiring by using the existing
wire channels. To minimise damage to the cables, take care that they do not
pass sharp edged metal. Lay all cables as far away as possible from the
ignition cables, modules in the boot and under the key dashboard as these
create interference.
Add a fuse into the (+) power cable in a distance of not more than 30 cm
from the positive battery pole.
Keep the length of the power wires as short as possible. It is better to use
power cables which are short and then longer speaker cables. In order to
reduce interference, also pay attention to the instructions.
16
© Toxic 2004