To Fix The Unit On The Mounting Plate; Configuration; To Set A Different Address - Daikin Comfora FTXP20M5V1B Manuel D'installation

6 Configuration

5.5.3

To fix the unit on the mounting plate

1 Set the indoor unit on the mounting plate hooks. Use the " "
marks as a guide.
2 Press the bottom frame of the unit with both hands to set it on
the bottom hooks of the mounting plate. Make sure that the
wires do NOT get squeezed anywhere.
Note: Take care that the interconnection cable does NOT get
caught in the indoor unit.
3 Press the bottom edge of the indoor unit with both hands until it
is firmly caught by the mounting plate hooks.
4 Secure the indoor unit to the mounting plate using 2 indoor unit
fixing screws M4×12L (accessory).
6 Configuration
6.1

To set a different address

In case 2 indoor units are installed in 1 room, different addresses for
2 user interfaces can be set.
1 Remove the batteries from the user interface.
2 Cut the address jumper.
a
a Address jumper
NOTICE
Be careful NOT to damage any of the surrounding parts
when cutting the address jumper.
3 Turn the power supply on.
Result: The flap of the indoor unit will open and close to set the
reference position.
INFORMATION
▪ For FTXF units, the following setting MUST be
completed within 5 minutes after the power supply is
turned on.
▪ In case you could NOT complete the setting in time,
turn the power supply off and wait at least 1 minute
before turning the power supply back on.
4 Press simultaneously:
Model Buttons
FTXP and ATXP
FTXF
5 Press:
Model Button
FTXP and ATXP
Installation manual
10
a
, and
, and
Model Button
FTXF
6 Select:
Model Symbol
FTXP and ATXP
FTXF
7 Press:
Model Button
FTXP and ATXP
FTXF
ON/OFF
a Operation lamp
b Indoor unit ON/OFF switch
8 Press the indoor unit ON/OFF switch while the operation lamp
is blinking.
Jumper Address
Factory setting 1
After cutting with nippers 2
INFORMATION
If the setting could NOT be completed while the operation
lamp was blinking, repeat the setting process from the
beginning.
9 When the setting is complete, press:
Model Button
FTXP and ATXP
Keep
5 seconds.
FTXF
Result: The user interface will return to the previous screen.
10 Press simultaneously:
Model Buttons
FTXP
FTXF
11 Press:
Model Button
FTXP
FTXF
12 Select:
Model Symbol
FTXP
FTXF
a
b
pressed for about
, and
, and
(A)(F)TXP20~35M5V1B
Daikin room air conditioner
3P519299-4B – 2018.12