Installation; Opening The Indoor Unit; To Remove The Front Panel; To Re-Install The Front Panel - Daikin Comfora FTXP20M5V1B Manuel D'installation

5

Installation

5.1

Opening the indoor unit

5.1.1

To remove the front panel

1 Hold the front panel by the panel tabs on both sides and open
it.
a Panel tabs
2 Remove the front panel by sliding it to the left or the right and
pulling it toward you.
Result: The front panel shaft on 1 side will be disconnected.
3 Disconnect the front panel shaft on the other side in the same
manner.
a
a Front panel shaft
5.1.2

To re-install the front panel

1 Attach the front panel. Align the shafts with the slots and push
them all the way in.
2 Close the front panel slowly; press at both sides and at the
centre.
5.1.3

To remove the front grille

CAUTION
Wear adequate personal protective equipment (protective
gloves, safety glasses,...) when installing, maintaining or
servicing the system.
1 Remove the front panel to remove the air filter.
2 Remove 2 screws from the front grille.
3 Push down the 3 upper hooks marked with a symbol with 3
circles.
b
a
a Upper hook
b Symbol with 3 circles
(A)(F)TXP20~35M5V1B
Daikin room air conditioner
3P519299-4B – 2018.12
4 We recommend opening the flap before removing the front
grille.
5 Place both hands under the centre of the front grille, push it up
and then toward you.
a
5.1.4
1 Install the front grille and firmly engage the 3 upper hooks.
2 Install 2 screws (class 20~35) back on the front grille.
3 Install the air filter and then mount the front panel.
5.1.5
1 Remove the front grille.
2 Remove 1 screw from the electrical wiring box.
3 Open the electrical wiring box cover by pulling the protruding
part on the top of the cover.
4 Unhook the tab on the bottom and remove the electrical wiring
box cover.
c
5 To re-install the cover, first hook the bottom tab onto the
electrical wiring box, and slide the cover into the 2 upper tabs.
5.1.6
1 Remove 1 screw from the service cover.
a
2 Pull out the service cover horizontally away from the unit.

To re-install the front grille

To remove the electrical wiring box cover

a
b
a
a Tab
b Protruding part on the top of the cover
c Screw

To open the service cover

a b
a Service cover screw
b Service cover
5 Installation
3
a
Installation manual
5