Using Your Door Control - Chamberlain B4505Tc Manuel D'installation

Operation

Using your Door Control

MOTION DETECTING CONTROL PANEL
Motion Sensor
Switch
LEARN Button
LOCK Button
LIGHT Button
Motion Sensor
SYNCHRONIZE THE DOOR CONTROL: To synchronize the door control to the garage door
opener, press the push bar until the garage door opener activates (it may take up to 3 presses).
Test the door control by pressing the push bar; each press of the push bar will activate the garage
door opener.
PUSH BAR: Press the push bar to open or close the door.
LEARN BUTTON: Use to program compatible remote controls, wireless keyless entries and
myQ ® devices to the garage door opener.
MOTION SENSOR: Turns the garage door opener lights on when motion is detected. Lights
stay on for 4-1/2 minutes (factory setting), then turn off. Set the motion sensor switch ON or
OFF to control this feature.
Push Bar
Command LED
LOCK: Prevents remote controls from working, while still allowing activation from the door control
and keyless entry. (Factory setting is OFF.)
Turn ON: Press and hold the LOCK button for 2 seconds. The command LED will flash as long as
the lock feature is on.
Turn OFF: Press and hold the LOCK button for 2 seconds. The command LED will stop flashing and
normal operation will resume.
36