Recommended Measures To Secure The Tv - Sony BRAVIA KDL-48W650D Manuel D'instructions

Recommended Measures to Secure
the TV
Consider the following measures when
securing your TV to a Stand (not supplied).
1
Secure the Stand for the TV.
Make sure the Stand can adequately
support the weight of the TV. Use
two angle braces (not supplied) to
secure the Stand.
For each angle brace use the
appropriate hardware to:

Attach one side of the angle brace to
the wall stud.
 Attach the other side to the Stand.
2
Secure the TV to the Stand.
Use the optional hardware listed as
follows (not supplied):

M6 machine screws (screwed into the
TV's rear cover).
 A screw or similar (attach it to the
Stand).

Rope or chain (strong enough to
support the weight of the TV). Make
sure that there is no excess slack in the
rope or chain.
Screw hole
on the rear
cover
Rope or
chain
(not
supplied)
8
US
Angle braces
(not supplied)
Stand
M6 machine
screw
(not supplied)
Screw
(not supplied)
The length of the M6 machine screw
differs depending on the rope or chain
diameter. Please refer to below
illustration.
10 mm - 12 mm
TV Rope or chain
3
Anchor the TV to the wall by using
bolts, wall anchor and chain (or
rope).
Wall-mount holes
M6 eye
bolts
(not
supplied)
Please see below illustration for M6 eye
bolt length.
10 - 12 mm
VS
TV's rear cover
Note
• Securing the TV to the Stand without securing
the TV and the Stand to the wall provides
minimum protection against the TV toppling
over. For further protection, be sure to follow the
three measures recommended.
Screw M6
VS
Rope or chain
(not
supplied)
Wall-anchor
VS
(not supplied)
M6 eye
bolt