Additional Information; Using A Wall-Mount Bracket; Detaching The Table-Top Stand From; The Tv - Sony BRAVIA KDL-48W650D Manuel D'instructions

Additional Information

Using a Wall-Mount Bracket

This TV's instruction manual only shows the
steps on preparing the installation of the TV
before installing to the wall.
Your TV can be mounted on a wall using a
Wall-Mount Bracket (not supplied) out of
the box as packaged. If the Table-Top Stand
is attached to the TV, the TV may require
detaching the Table-Top Stand; see page 40
(Detaching the Table-Top Stand from the
TV).
Prepare the TV for the Wall-Mount Bracket
before making cable connections.
For product protection and safety
reasons, Sony strongly recommends that
installation of your TV on the wall be
performed by qualified professionals. Do
not attempt to install it yourself.
 Follow the instruction guide provided with
the Wall-Mount Bracket for your model.
Sufficient expertise is required in installing
this TV, especially to determine the
strength of the wall for withstanding the
TV's weight.

The length of the screw for Wall-Mount
Bracket differs depending on the Wall-
Mount Bracket thickness. Please see
below illustration.
10 mm - 12 mm
Screw (supplied with the
Wall-Mount Bracket)
Wall-Mount Bracket
 Be sure to store the unused screws and
Table-Top Stand in a safe place until you
are ready to attach the Table-Top Stand.
Keep the screws away from small children.
Note
• Read the supplied Safety Booklet for additional
safety information.
40
US

Detaching the Table-Top Stand from

the TV

To detach the Table-Top Stand from the TV,
remove the screws.
Note
• Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
• When removing the Table-Top Stand from the TV,
lay the display face down on a stable work
surface that is larger than the TV.
• To prevent damaging the surface of the LCD
display, make sure to place a soft cloth on the
work surface.
• Be sure the TV is vertical before turning on. To
avoid uneven picture uniformity do not power on
the TV with the LCD panel facing down.
• When attaching the Table-Top Stand again, be
sure to fasten the screws (previously removed) to
the original holes on the rear of the TV.