SSS Siedle Classic CBCM 653-0 Information Produit page 6

English
Application
Camera 130 or camera 180 for
Siedle Classic. Available for the sys-
tems In-Home bus, Access or as a
system-free camera.
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
1 In the case of video systems, the
following mounting situation must
be avoided at all costs:
• direct ajour light
• direct sunlight
• very bright image backgrounds
• highly reflective walls opposite the
camera
• lamps or direct light sources
Mounting
2 Recommended mounting height
appr. 1.60 m to centre camera.
3 Pick-up angle of the camera with
an angle of aperture of appr. 130°
4 Pick-up angle of the camera with
an angle of aperture of appr. 165° in
the full screen mode.
5 With an angle of aperture of
appr. 165°, the pick-up angle of
the camera can be adjusted to any
mounting situation. Open the flap
on the back of the module with the
aid of a screwdriver.
6 Select the picture excerpt based
on the existing mounting situation.
a Picture excerpt (1-3)
top camera alignment
b Picture excerpt (4-6)
central camera alignment
c Picture excerpt (7-9)
bottom camera alignment
6
Terminal assignment
CBCM 653-.../CBCM 658-...
TaK In-Home bus
TbK camera branch
Ta In-Home bus
Tb
Vc Camera actuation
GND
b Power supply 12 V AC
c
CACM 673-.../CACM 678-...
V1 video signal
V2 (two-wire FBAS)
V3 Camera supply
V4
V5 Actuation of video output
V6
CCM 613-.../CCM 618-...
+M Supply voltage
-M 10–50 V DC
Vc Camera actuation
-
VKA Actuation of
camera distributor
A1 Potential-free contact
A1
b Power supply 12 V AC
c
coaxial connection
L/S L = lead, S = shield
Installation
Installation, commissioning and pro-
gramming are described in the rel-
evant system manual and enclosed
with the line rectifier/server.
Servicing
If a camera has to be exchanged,
this is unplugged at the terminal
block and replaced.