Publicité
Les langues disponibles
Les langues disponibles
MW-650-4DSM.book Seite 38 Dienstag, 16. Mai 2006 4:28 16
Installing MagicWatch
6.4
Fastening the control electronics
Note the following information when selecting a place to fit the control elec-
tronics:
Note the length of the sensor cables.
The control electronics are watertight and can be fitted inside or outside
the vehicle.
The control electronics may not be damaged if you have luggage or
objects in the boot.
If you fit the control electronics to the outside of the vehicle, they must be
protected against grit or similar dangers.
➤ Fasten the control electronics in a suitable position.
Note
The extension cables are marked: L (left), CL (centre left),
R (right), CR (centre right).
This marking helps you connect them to the control electronics to
ensure that the display is correct. These markings can also be
found on the control electronics.
The plug polarities cannot be reversed: They can be only be
plugged into the connection in one way.
➤ Insert the plugs of the sensor extension cables into the corresponding
sockets on the control electronics (see fig. 15 B, page 7).
Make sure the locking pin catches.
38
MagicWatch MW650
Publicité
