GE AFHC32AM Manuel Du Propriétaire page 3

About the controls on the air purifier.
Auto
setting Circulation
Fan speed
indicator
indicator
indicator
SPEED
1 2 3 4 5
Manual Controls
Power On/Off Button
Press to turn the air purifier on and off.
Filter Reset Button
The filter reset indicator light will come
on when the filter needs to be replaced.
To reset the filter indicator after replacing
the filter, if no filter lights are on:
For the Pre-Filter, press the FILTER RESET
button once and the Pre light will flash; then
press and hold for 2 seconds. The indicator
light for the filter will go off.
For the 99.97% True HEPA Filter, press
the FILTER RESET button twice and the
HEPA light will flash; then press and hold
for 2 seconds. The indicator light for the filter
will go off.
To reset the filter indicator after replacing
the filter, if one or both lights are on:
Press and hold the FILTER RESET button
for 2 seconds. One or both indicator lights
will go off.
Timer Selector
Press to select from timer hour settings 1 hr.,
2 hr., 4 hr., 8 hr. or OFF. The air purifier will run
for the selected number of hours and then
turn off.
Circulaire Selector
Press to set the circulation grille On or Off.
When CIRCULAIRE is On, the circulation
grille will move to circulate airflow. When
CIRCULAIRE is Off, the grille will stop but
remain open. After 6 hours of operation,
the unit will automatically turn off.
Night
Timer indicator
indicator
TIMER 1h 2h 4h 8h Pre-Filter
AUTO
CIRCULAIRE
AIR
HEPA
AUTO CIRCULAIRE NIGHT POOR GOOD
Air quality
indicator
Filter reset
indicator
SPEED CIRCULAIRE
1-5/AUTO
LIGHT
SENSOR
Fan Speed Selector
Press to adjust the fan motor speed setting
from levels 1, 2, 3, 4, 5 and AUTO. The Fan
Speed indicator shows the setting level
the fan is on.
In AUTO mode, the fan speed is automatically
adjusted according to the dust level of the
room. The Auto Setting indicator light will
be on when the Speed is set to AUTO.
Light Sensor/Night Mode
When the air purifier is On and set to AUTO,
the Light Sensor will detect the loss of light for
more than 3 minutes. If this happens, the unit
goes into Night Mode. When the Light Sensor
detects bright light again, normal operations
resume.
ge.com
TIMER FILTER RESET
Pre / HEPA
3