Publicité
Les langues disponibles
Les langues disponibles
1. Turn pedestal on its side to match orientation to appliance.
5, After retuning appliance upright, loosen each mounting screw
2. Slide pedestal up to appliance and line up holes in mounting
going into appliance base. Allow the appliance to settle in the
brackets with holes in appliance base.
brackets and retighten each mounting screw.
3. Attach rear and front brackets to appliance base with supplied
.
screws into aligning holes - one in each front bracket and two in
WASHER:
each rear bracket.
4.
Using more than one person, carefully return appliance and ped-
estal to upright position.
A\ CAUTION
EXCESSIVE WEIGHT HAZARD
TO avoid back or other injury, have more than one person move
or li the appliance.
ad
IMPORTANT
DO NOI use open dispenser drawer of washer or dispenser
Cavity as handhold location when tipping washer upright.
Serious damage could occur to your washer
Washer on pedestal:
Dryer on pedestal:
1.
Slide washer/pedestal into place.
1.
Slide dryer/pedestal into place.
2.
Check for levelness and rock all four (4) legs again. Repeat
2.
Check for levelness and rock all four (4) legs again. Repeat
until level and solid.
until level and solid.
3.
Refer to Washer Installation instructions for complete details
3.
Refer to Dryer Installation Instructions for complete details on
on installing water, drain, or electrical.
installing electrical, gas, or exhaust venting.
Publicité
