Publicité
Les langues disponibles
Les langues disponibles
REMOTE CONTROL
Screwdriver required.
Your VMH600 heater remote includes (1) coin-style CR2032 battery. Battery comes pre-installed. Remove battery pull tab before first use. The
remote is wrapped inside a polybag and packed in the top of the product inside the retail carton.
1. For battery replacement, the remote
requires one coin-style 3V CR2032 battery.
Always use the correct size and grade of
battery for this product.
2. To replace battery, open battery door
on the back side of the remote control
(you will need to loosen the small screw
on door using a #1 Phillips screwdriver
- screwdriver not included). If necessary,
clean the battery contacts and also those
of the device prior to battery installation.
Remove any plastic protection from the
battery and place it in the remote with the
+ side facing up. Replace the battery door
and screw.
Note: Remove battery from the remote
control when not in use for an extended
period of time and always remove dead
battery immediately and replace with
fresh. Do not store dead battery in remote.
12 English
3. Your remote control will operate the
same as the control functions located
on the heater, except when changing
POWER
modes. When changing modes, both
THERMOSTAT -/+
displays will show either LO, HI or FA
on the display as you cycle through.
MODE
Once the selection is made, it will
High Heat (1500
hold for eight seconds before room
watts), Low Heat
temperature is displayed again.
(750 watts) or Fan
Only.
The remote requires a line-of-sight path
to allow for the signal to be received
by the heater. Position the heater so
TIMER
the receiver lens (inside the display
on front of heater) is visible from the
remote control.
CAUTION: DO NOT
INGEST BATTERIES.
CLEANING
Because your heater moves a substantial amount of air, it will need regular cleaning. Cleaning the outside of the heater is recommended
on a bi-weekly basis. If service is required, return your heater to Vornado. See WARRANTY for instructions.
1. Unplug heater before cleaning.
2. Use brush attachment on
household vacuum cleaner to
vacuum any accumulated dust
off Front Outlet Grill.
You may also clean the heater
with high-pressured air, as well.
3. Use brush attachment on
household vacuum cleaner to
vacuum any accumulated dust off
Inlet Filter on back of heater.
4. Wipe down entire heater with
soft, dry cloth.
Note: Inlet Filter on back of heater
is not removable.
English
13
Publicité
