Leckey sleepform 1 Mode D'emploi page 8

Always remember more air can be let back into
the bag at any time to make it more flexible
and easier to mould. To do this close the valve,
remove the pump and momentarily opening the
valve again allowing air back into the mattress.
Experiment with this so you are confident in
moulding the mattress.
Once all the air is removed, the mattress will be
rigid and the beads will become more visible on
the outer surface.
We recommend you check the Sleepform
mattress daily and remove air occasionally
if you find it is getting soft.
Positioning the Sleepform Mattress on the bed
Set the Sleepform Mattress in the area where
you will need the support. The Mattress is
designed in a "U" shape so that one end has
beads in it to aid with positioning. This is the
end the valve is attached to.
Place the bag in the middle of the bed with
the channel in the middle.
Where you want to provide a pommel for leg
abduction you can keep the air valve towards
the middle of the bed.
Alternatively, if you wish to focus on head
positioning, you can position the bag with
the valve to the top of the bed.