Leckey sleepform 1 Mode D'emploi page 11

Continue extracting the air.
Continue moulding the support at the sides.
Once you have the desired shape or support
close the valve and remove the pump.
Then remove the child from the mattress.
While the child is out you can contour the form
or mould some cavities for your child to relax
into. To do this open the valve for 5 seconds and
allow some air back into the Sleepform Mattress.
You can then mould any specific cavities to
allow extra comfort around any potential
pressure points or create prompts to assist
with passive correction while the child is resting.
Also this allows extra space to make room for
the Air-Flow Mattress.
Once you are happy with the shape, reattach
the pump, open the valve and extract the last air
to make the support rigid again. Close the valve
and remove the pump.
Place the Air-Flow mattress over the Sleepform,
pushing it down into the cavity.
Fit a standard sheet over the Sleepform and
the Air flow mattress – for a single bed you
may have to use a double bed size sheet and
for a cot you may need to use a single bed size
sheet – this will depend on the components
being used.
Then place your child back onto the bed.
Make sure the Sleepform Mattress is not
moulded too tightly around your child. If it is
too tight you may have to open the valve and
allow some air into the mattress again.
Always remember to extract the air again once
the desired shape has been achieved and finally
close the valve and remove the pump.