Danby DKC054A1BSL2DB Guide D'utilisation Et D'entretien page 18

Troubleshooting
Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time
PROBLEM
The unit does not operate •
Turns on and off
frequently
Vibrations
The keg cooler seems to
make too much noise
The door will not close
properly
Excessive beer foam
Weak beer fl ow
Danby Consumer Care: 1-800-263-2629
Not plugged in
• The circuit breaker tripped or blown fuse
• The room temperature is hotter than normal
• The door is open too often
• The door is not closed completely
• The temperature control is not set correctly
• The door gasket does not seal properly
• The unit does not have proper clearance
• Check that the keg cooler is level
• The rattling noise may come from the fl ow of refrigerant, which is
normal
• Gurgling, caused by liquid refrigerant cycling is normal
• Contraction and expansion of the inside walls may cause popping
and crackling noises
• The keg cooler is not level
• The keg cooler is not level
• The door was reversed and not properly reinstalled
• The gasket is dirty
• The shelves or stand are out of position
• The keg is not properly centered in the unit
• The casters are not attached
• Ensure the beer line hose from the tower and the CO
from the CO regulator are attached to the correct connections on
2
the coupler; beer line to the top of the coupler, CO
side of the coupler
• Check that there are no leaks in any connections
• Ensure that the reed valve in the CO
has a hole in it
• The CO pressure may be set too high; try turning the pressure
2
down
• Ensure that the valve spool plastic rod is inserted into the coupler
• Ensure the beer line hose from the tower and the CO
from the CO regulator are attached to the correct connections on
2
the coupler; beer line to the top of the coupler, CO
side of the coupler
• Check that there are no leaks in any connections
• Ensure that the reed valve in the CO
has a hole in it
• The CO pressure may be set too low; try turning the pressure up
2
• Ensure there are no bends or kinks in any of the hoses that could
impede fl ow
15
POSSIBLE CAUSE
connection at the coupler
2
connection at the coupler
2
air line hose
2
air line to the
2
air line hose
2
air line to the
2