Télécharger Imprimer la page

Greencut GWP200X Manuel D'utilisation page 53

Pompe à moteur

Publicité

Les langues disponibles
  • FR

Les langues disponibles

MAINTENANCE
Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
ATTENTION: If the water pump is used to pump water from the sea, please pump fresh water right
after pumping the seawater to reduce signs of corrosion and to remove sediment from seawater.
MAINTENANCE
Oil level Check
Oil change
Air filter
Spark plug
Fuel supply pipe
Turbine
Water pump reservoir
cap
Water inlet valve
OIL CHANGE
Drain the oil when the engine is still hot to ensure rapid and complete drainage.
1.
Remove the plug / dipstick from the oil tank and the drain plug to drain the oil.
2.
Re-install the drain plug and tighten it firmly.
3.
Refill with the recommended oil up to the indicated level..
Please dispose of used motor oil respecting the environment. We suggest you take it in a sealed container to your local
recycling centre or to a service station for recovery. Do not throw it in the bin or pour it on the ground.
EVERY MONTH
EVERY USE
OR 20H USE
Check
Check
Check
EVERY 6
EVERY 3
MONTHS OR
MONTHS OR
100H USE
50H USE
MAINTENANCE
Change oil
Replace
Clean or
replace
53
EN
EVERY 12
MONTHS OR
300H USE
Clean or
replace
Replace
Check
Check
Check

Publicité

loading